Well pumps are a great construction tool when your building site doesn't have access to a public water supply. However, it's important to make sure that the well pump is correctly installed in order to be efficient and avoid contamination. Aside from having your well installed by a professional, there are some checks that you can perform to make sure that the pump is installed correctly. 

Check the Seal

The first thing that you can easily do is to check the casing and the seal between your pump and the ground. If your pump was constructed using cement, make sure there are no bubbles in the cement or gaps between the cement and the pump. If the pump was bumped or moved while the cement was drying, this can cause a faulty seal. 

Evaluate the Casing

Since there is some pressure on the well during installation, cracks can develop in the watertight casing. Make sure there are no visible deformities with the pump itself. 

Make Sure There is Enough Pump Extending From the Ground

The pump needs to extend out of the ground in order to keep water from running into the well. Check your owner's manual and make sure that the pump extends far enough out of the ground to prevent surface water contamination. If you live in a rainy or flood-prone area, then you might leave a few extra inches of casing above ground to keep the surface water out. 

Check for Surface Area Protection

Another point to check is whether the area around the wellhead is protected from contaminants. One of the easiest ways to do this is to create a graded area around the wellhead; make sure that contaminants will flow away from the wellhead and not towards it. 

Check the Seal Points for Extension Points

There are a few other areas that need to be protected from contaminants; if your well contains piping, electrical components, or monitoring equipment, then these areas need to be sealed thoroughly with grout or cement. Make sure there is no gap near these pieces of equipment; contaminants can easily seep in at these entry points. 

Once well pumps are correctly installed by a company like T. W. Stanley & Son Well Pump & Plumbing Repair, they can be an efficient and clean source of water for residents. Although you should have a professional install your well to make sure it's safe, there are things that you can do before and after construction to ensure that the well is constructed properly. These steps should help you to make sure there are no leaks or problems with your water supply.

Share